Replacing An Ecc800-Pro Psu - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Figure 7-2 Installing a SIM card
Step 7 Install the spare ECC800-Pro main control module in the ECC800-Pro subrack and
tighten the screws on both sides of the ECC800-Pro main control module.
Step 8 Connect the communications cables and antennas to the ECC800-Pro main control
module.
Step 9 Choose Maintenance > Configuration File and import the backup configuration
file, or set parameters for the devices that connect to the ECC800-Pro to ensure
normal communication.
----End

7.2.1.2 Replacing an ECC800-Pro PSU

Prerequisites
Do not touch the terminals in the rear of a removed PSU to avoid electric shocks.
●
●
Context
The PSU is hot-swappable.
Procedure
Step 1 Push the locking latch in the upper right corner of the PSU panel leftwards.
Step 2 Pull out the handle of the PSU to remove the PSU from the subrack.
Step 3 Gently push the reserved PSU into the subrack along guide rails, and push the
locking latch rightwards to secure the handle.
Issue 02 (2021-05-12)
D ANGER
Tool: insulation gloves
Materials: a reserved undamaged and undeformed PSU of the appropriate
model.
Copyright © Huawei Technologies Co., Ltd.
7 Device Maintenance
287