Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 57

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
4.
5.
Issue 02 (2021-05-12)
Figure 3-46 Installing a filler panel for guide rails
Install the cage nuts that secure the IVS1800. The cage nut installation
locations are the first and sixth holes along the guide rails, as shown in the
following figure.
Figure 3-47 Installing cage nuts
Install mounting ears. Use a PH2 screwdriver to secure the mounting ears to
both sides of the front panel of the device with four screws on each side.
When the device is near the front door of the cabinet, fasten screws in hole
groups 1 and 2; when the device is near the rear door, fasten screws in hole
groups 2 and 3.
Copyright © Huawei Technologies Co., Ltd.
3 Installing Devices
46