Creating An Icon For A Door Status Sensor On The Neteco - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Step 4 Click Submit.
Step 5 Select NO or NC for AI/DI_1 Sensor Type from the drop-down list.
Figure 6-71 Setting the sensor type of a dry contact
● NO: indicates a normally open dry contact. The dry contact will report an alarm in the
normally closed state.
● NC: indicates a normally closed dry contact. The dry contact will report an alarm in the
normally open state.
Step 6 Click Unhide All Advanced Signals, then click Power Supply Parameters. Ensure
that III power supply enable(AIDI_1/DO) is Yes.
Step 7 Click Submit.
----End

6.5.2.1.4 Creating an Icon for a Door Status Sensor on the NetEco

This section describes how to create and configure an icon for a door status sensor
in an equipment room or container.
Prerequisites
You have the operation rights for configuring View.
Procedure
Step 1 Log in to the NetEco client.
Step 2 Choose Device Management > Device View > View from the main menu.
Step 3 On the view page, double-click the equipment room or container where the door
status sensor is installed.
Step 4 Click
Step 5 Drag
displayed in the view. The Property Panel dialog box is displayed.
Issue 02 (2021-05-12)
NO TE
on the toolbar on the left. The Toolbox dialog box is displayed.
in the toolbox to the position where the door status sensor needs to be
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
244