Connecting The Ups5000-A Monitoring Cable - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)

4.2.5.2 Connecting the UPS5000-A Monitoring Cable

Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of a network cable to the FE port of the UPS5000-A.
Figure 4-12 UPS5000-A-30 kVA/40 kVA functional components and control signal
ports
(1) FE port
Figure 4-13 UPS5000-A-60 kVA/80 kVA/120 kVA functional components and
control signal ports
(1) FE port
Figure 4-14 FE port on the UPS monitoring module of the 300 kVA UPS and
models with higher capacities
(1) FE port
Step 2 Connect the other end of the network cable to the Ethernet port on the LAN
switch.
----End
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
85