Connecting A Monitoring Cable To The Ups5000-E/Ups5000-H/Ups5000-S; Connecting The Smartli Monitoring Cable - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
4.2.5.3 Connecting a Monitoring Cable to the UPS5000-E/UPS5000-H/
UPS5000-S
Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of a network cable to the FE port on the UPS5000-E/UPS5000-H/
UPS5000-S monitoring card.
Step 2 Connect the other end of the network cable to the Ethernet port on the LAN
switch.
----End

4.2.6 Connecting the SmartLi Monitoring Cable

Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of the network cable to the FE port on the monitoring interface
unit.
Figure 4-15 Monitoring interface unit of the SmartLi
(1) Monitoring interface unit
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
86