Installing A Region-Type Water Sensor - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
(1) UIM20A expansion module (2) T/H sensor
----End

3.7.7 Installing a Region-type Water Sensor

Context
A water sensor consists of a water detection cable, water detector, and conversion
cable. The water detection cable is laid out on the floor, connecting to the water
detector placed near the collector by the conversion cable.
Figure 3-28 Water sensor components
(1) Water detector
(4) Conversion cable end B,
connecting to the water
detection cable
Procedure
Step 1 Install the water detector near the collector and secure it using screws or other
methods.
Step 2 Connect the water detection cable to the conversion cable.
Issue 02 (2021-05-12)
(2) Conversion cable end A,
connecting to the water
detector
(5) Water detection cable end
A, connecting to the
conversion cable
Copyright © Huawei Technologies Co., Ltd.
3 Installing Devices
(3) NTC sensor
(3) Conversion cable
(6) Water detection cable
37