Setting Neteco Parameters - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
●
----End

6.5.1.5 Setting NetEco Parameters

Procedure
Step 1 Apply for a fixed IP address to the equipment room network administrator.
Step 2 Sett ECC800-Pro communications parameters.
●
●
Step 3 Set NetEco communications parameters and authentication password on the
ECC800-Pro WebUI.
Issue 02 (2021-05-12)
If the port has been used, you will be prompted that the transparent
transmission function cannot be enabled and you need to select an idle port.
(WAN1 port networking) On the ECC800-Pro WebUI, set the IP address,
subnet mask, and default gateway, and click Submit.
Table 6-28 IP parameters
Path Paramete
r
System IP
Settings >
System
Paramete
Subnet
rs >
mask
Monitor
IP >
WAN_1
Default
gateway
(4G networking) Set mobile data parameters on the ECC800-Pro WebUI.
Table 6-29 Mobile data
Path Paramete
r
Choose Mobile
System data
Settings > control
System
Paramete
rs >
Mobile
Data.
Copyright © Huawei Technologies Co., Ltd.
Default Setting
Value
192.168.8. Set this parameter based on the IP
10 address assigned by the network
administrator.
255.255.25 Set this parameter based on the
5.0 subnet mask assigned by the
network administrator.
192.168.8. Set this parameter based on the
1 default gateway address assigned by
the network administrator.
Default Setting
Value
Disable Set this parameter to Enable and
click Submit.
6 Adding Devices
233