Scenarios For Connecting The Ecc800-Pro Outside The Smart Module; Setting And Adding The Ecc800-Pro Collector; Preparations And Login - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
6.5 Scenarios for Connecting the ECC800-Pro Outside
the Smart Module

6.5.1 Setting and Adding the ECC800-Pro Collector

6.5.1.1 Preparations and Login

Prerequisites
●
●
●
Procedure
Step 1 Connect a network cable between the PC network port and the WAN1 port
(protected by a security mechanism) on the ECC800-Pro.
Table 6-26 Default IP addresses for the WAN and LAN ports on the ECC800-Pro
Port
WAN1
WAN2
LAN1 and LAN2
● In ECC800 V100R002C10 and earlier versions, the default IP address of port
WAN_1 is 192.168.1.10.
● The WAN1 port IP address cannot be set to an IP address in any of the
following network segments: 192.168.0.x, 192.168.245.x, 192.168.246.x and
192.168.248.x.
● IP addresses for the WAN1 and WAN2 ports should not be set in the same
network segment.
● In some customized scenarios, the default IP address for the WAN2 port is
192.168.248.10. The default value may vary.
● WAN ports support the Internet access and LAN ports support the intranet
access. Connect the PC network port to the WAN1 port or LAN port on the
ECC800-Pro based on the access network.
Issue 02 (2021-05-12)
Supported operating system: Windows 7 and later versions
It is recommended that the screen resolution be 1366 x 768 or higher.
Browser: Chrome, Firefox 32, Internet Explorer 11 or later
NO TICE
Copyright © Huawei Technologies Co., Ltd.
Default IP Address
192.168.8.10
192.168.0.10
192.168.248.10 (FusionModule800)
192.168.248.10
6 Adding Devices
226