Installing The M2121 Camera - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Figure 3-53 Adjusting the camera
Step 5 Align the transparent cover with the screw holes on the base, close the
transparent cover, and use a Phillips screwdriver to tighten the screws to 0.8 N·m.
Figure 3-54 Installing the transparent cover
----End

3.8.3 Installing the M2121 Camera

Cameras can be installed on different objects based on scenarios. This section
describes how to install a M2121 camera on the wall.
Prerequisites
●
●
●
Issue 02 (2021-05-12)
NO TE
The camera features a three-axis design. The camera can be adjusted by –175° to +180°
horizontally, and the lens can rotate –175° to +180° and be adjusted by 0° to 65° vertically.
A camera and tools for installing it have been prepared.
A network cable for connecting the camera to the LAN switch has been
prepared.
The LAN switch has been normally powered on.
Copyright © Huawei Technologies Co., Ltd.
3 Installing Devices
50