Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual page 196

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Step 5 In the left part of the dialog box, select VCN or IVS as required.
Step 6 In the right part of the dialog box, set the parameters according to
If not all ActiveX controls are enabled, the test connection fails after filling in the
correct parameter information and clicking Test.
Table 6-8 Parameter description
Parameter
Server Name
IP
Port
Issue 02 (2021-05-12)
NO TE
Video streaming media service has been enabled on the System > System Setting >
System Configuration > Protocols Configuration > NetEco Protocols page. If the service
is disabled, enable it by following the instructions provided in "Configuring Protocol Switch"
iMaster NetEco Product Documentation (DC) (V600R021C10_xx) .
in
NO TICE
Description
You can customize the server
name.
Indicates the IP address of the
VCN/IVS server. It is a correct
IPv4 address. Each digit ranges
from 0 to 255. The IP address
cannot be 0.0.0.0.
Indicates the port number of
the VCN/IVS server.
NOTE
● The default port number for
● The IVS server supports two
Copyright © Huawei Technologies Co., Ltd.
VCN is 9900.
access modes: eSDK and IVS.
The default port number of the
eSDK is 9900, and the default
port number of the IVS is
18531.
6 Adding Devices
Table 6-8.
Example
-
XXX.XXX.XXX.XXX
9900
185