Connecting Cables To The 4G Sms Modem - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
After the power cable is connected, switch on the power. Normally, the indicator
of the SMS modem blinks regularly.
the indicator status and the modem status.
Table 4-3 Relationships between the indicator status and the modem status
Indicator Status
On
Blinks slowly
Blinks quickly
Off
Step 6 Install the SMS modem driver.
To install the SMS modem driver, see the specifications delivered with the SMS
modem.
----End

4.1.3 Connecting Cables to the 4G SMS Modem

Prerequisites
An idle USB port is available on the server.
Context
The following figure shows the ports on the 4G SMS modem.
Figure 4-4 Ports on the 4G SMS modem
(1) SIM card slot
Issue 02 (2021-05-12)
NO TE
You need to install the driver only when the installation of the driver is required in the
specifications delivered with the SMS modem.
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
Table 4-3 describes the relationships between
Modem Status
The SMS modem is activated and is not registered
with the network.
The SMS modem is connected to the network and
is in idle mode.
The SMS modem is in transmission mode.
The SMS modem is deactivated.
(2) USB 2.0 port (3) External antenna port
(SMA port)
71