Connecting A Monitoring Cable To The Door Status Sensor - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
BOM
Number
14180327
25031053
14180327
25030393

4.3.5.2 Connecting a Monitoring Cable to the Door Status Sensor

Prerequisites
A monitoring cable required is prepared.
Context
When connecting the door status sensor to an ECC800-Pro collector or a UIM20A
expansion module, you need to perform the following steps to prepare a special
monitoring cable.
Procedure
Step 1 Open the door status sensor, connect two cables, as shown in
Figure 4-35 Connecting a monitoring cable to the door status sensor
Issue 02 (2021-05-12)
BOM Description
Terminal Block, 4-Pin, Screw Fixed,
24–12 AWG, Pitch 5.08 mm, Male and
Female Using Together, Only for
Power Supply
Electric Cable, 300V, UL2464,
7x20AWG, Black(7Cores: Red, Black,
Yellow, Green, Orange, White, Blue),
9A, Non-shielding Cable, UL
Terminal Block, 4-Pin, Screw Fixed,
24–12 AWG, Pitch 5.08 mm, Male and
Female Using Together, Only for
Power Supply
Electric Cable, 300V/500V, 60227 IEC
53(RVV), 2x0.75mm
Brown, Blue), 6A, Flat Outdoor Cable,
CCC, CE
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
Cable Position
Cable from the card
reader to the access
controller
Cable from the door exit
button to the access
2
, Black(2Cores:
controller
Figure 4-35.
114