Creating A Ups On The Neteco - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)

6.5.6.2 Creating a UPS on the NetEco

This section describes how to create a UPS on the NetEco.
Prerequisites
●
●
●
●
Procedure
Step 1 Log in to the NetEco client.
Step 2 On the main menu, choose Device Management > Configuration > Planning
Configuration.
Step 3 Choose the management domain where you want to create a device from the
navigation tree on the left.
Step 4 In the lower-left corner of the page, click the Device tab.
Step 5 In the Device area, select UPS from the drop-down list box.
Step 6 Select the device to be added and drag its icon to the management domain.
Step 7 Click the device. In the device parameter area on the right, set device parameters
according to the following table.
Table 6-47 Modbus-RTU device parameter description
Parameter
Managed Object
Name
IP
Port
Device Address
Timeout Period
Issue 02 (2021-05-12)
You have the operation rights for Data Center Planning.
You have created a management domain for the device to be added on the
Data Center Planning page.
The ECC800-Pro connected to the device has been connected to the NetEco.
Transparent transmission has been enabled for the COM port on the ECC800-
Pro or UIM20A expansion module to which the device is connected.
NO TE
To delete a device, click the device and choose Delete under
Description
Device name
Set the IP address of the data collector to which the device
connects.
Set this parameter to the port through which the device
connects to the collector.
For details about the ports on the ECC800-Pro collector, see
6.5.1.4 Setting RS485 Parameters for the ECC800-Pro
Collector.
Set this parameter to the address set on the device.
Timeout duration for a connection test. The default value is
3s.
Copyright © Huawei Technologies Co., Ltd.
6 Adding Devices
.
268