iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Connecting Cables to the Card Reader with a Keypad
The following figure shows the cable connections to the access controller and card
reader with a keypad, using the cord end terminal to crimp the cable.
Figure 4-31 Connecting cables to the card reader with a keypad
Connecting Cables to the Single-Door Magnetic Lock, Double-Door
Magnetic Lock, and Emergency Door Release Button
●
●
Issue 02 (2021-05-12)
Table 4-32 Pin mapping for the RS485 port and the COM port
RS485 Port on Fingerprint and Card Reader
with a Keypad
Pin
Pin1
Pin2
The double-door magnetic lock is delivered with eight cables. Connect the
cables to the double-door magnetic lock, as shown in
cable on the access controller side using a cord end terminal.
Figure 4-33
shows the cable connections to the access controller, single-door
magnetic lock, and emergency door release button. Crimp the cables using
cord end terminals.
NO TE
● The magnetic lock is delivered with a small white terminal. Cut off the white
terminal and then use a cord end terminal for crimping.
● The cable installation sequences shown in the following figure are for reference
only. If any differences exist between the wiring diagram and this figure, the wiring
diagram prevails.
Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
Definition
485A (brown)
485B (gray)
COM Port on ECC800-
Pro Collector
Pin
Pin1
Pin2
Figure
4-32. Crimp the
109