Replacing A Fingerprint And Card Reader With A Keypad - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
Step 2 Remove the original bottom plate, as shown by (4) in
Step 3 Take out the bottom plate of the new card reader with a keypad and secure it.
Step 4 Connect the cable.
Step 5 Secure the card reader with a keypad to the bottom plate.
Step 6 Choose System > Service Settings > Data Center Planning from the main menu.
The Data Center Planning page is displayed.
Step 7 Select the new card reader with a keypad, and click Connection test. When
Connection success is displayed, the replacement is complete.
----End

7.2.6.7 Replacing a Fingerprint and Card Reader with a Keypad

Prerequisites
●
●
●
Context
Figure 7-42 Fingerprint and card reader with a keypad
Procedure
Step 1 Remove the screw that secures the fingerprint and card reader with a keypad, and
remove the cable, as shown by (1), (2), and (3) in
Issue 02 (2021-05-12)
Recommended tool: Phillips screwdriver
A fingerprint and card reader with a keypad needs to be replaced.
A spare fingerprint and card reader with a keypad of the same model is
available and functional.
Copyright © Huawei Technologies Co., Ltd.
7 Device Maintenance
Figure 7-41.
Figure 7-43.
317