Connecting A Monitoring Cable To The Region-Type Water Sensor; Connecting A Monitoring Cable To The Location-Type Water Sensor; Connecting The Smart Cooling Product Monitoring Cable; Connecting The Netcol5000 Monitoring Cable - Huawei iMaster NetEco V600R021C10 Device Installation And Commissioning Manual

iMaster NetEco
Device Installation and Commissioning Guide (Data
Center)
PIN
pin7
pin8
Step 2 Connect the other end of the network cable to the COM1/AIDI_1, COM3/AIDI_3,
COM5/AIDI_5, or COM7/AIDI_7 port on the UIM20A expansion module.
----End

4.3.6.6 Connecting a Monitoring Cable to the Region-type Water Sensor

Prerequisites
A monitoring cable is prepared.
Procedure
Step 1 Connect one end of the network cable to the Ethernet port on the water detector.
Step 2 Connect the other end of the network cable to the AI/DI port on the ECC800-Pro
collector or the UIM20A expansion module.
----End

4.3.6.7 Connecting a Monitoring Cable to the Location-type Water Sensor

Prerequisites
A network cable used for monitoring is prepared.
Procedure
Step 1 Connect one end of the network cable to the RJ45 port on the tie line.
Step 2 Connect the other end of the network cable to the live COM port on the ECC800-
Pro or the UIM20A expansion module.
----End

4.3.7 Connecting the Smart Cooling Product Monitoring Cable

4.3.7.1 Connecting the NetCol5000 Monitoring Cable

Prerequisites
A network cable used for monitoring is prepared.
Issue 02 (2021-05-12) Copyright © Huawei Technologies Co., Ltd.
4 Connecting Monitoring Cables to Devices
Definition
-
V-12V input
119