Installing Signal Cables For A Door Status Sensor; Installing An Alarm Signal Cable For The Cable Distribution Frame - Huawei ETP4860-B1A2 User Manual

ETP4860-B1A2 Embedded Power
User Manual

4.4.3 Installing Signal Cables for a Door Status Sensor

Prerequisite
If a door status sensor is required, perform the following steps to install the cable.
Procedure
Step 1 Connect the signal cable of the door status sensor to the SIG2 port GAT on the
SMU.
Figure 4-13 Installing signal cables for a door status sensor
(1) Door status sensor
----End
4.4.4 Installing an Alarm Signal Cable for the Cable
Distribution Frame
Procedure
Step 1 Connect the alarm signal cable for the cable distribution frame to the VD2 port on
the monitoring module.
Issue 04 (2021-01-05)
NO TE
Ensure that the RTN ground bar is installed.
Copyright © Huawei Technologies Co., Ltd.
4 Installation
43