ABB IRB 4400/60 Product Manual page 245

2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Product manual - IRB 4400
3HAC022032-001 Revision: Q
Action
CAUTION
Whenever parting/mating motor and gearbox, the
gears may be damaged if excessive force is used!
Note
The motor units from ELMO and YASKAWA are not
compatible!
Check that the assembly surfaces are clean from
paint, lubricant etc.
Make sure that the motor and the gearbox are not
damaged or scratched.
Fit the o-ring to the new motor unit.
Fit the measuring tool at the rear of the motor.
Release the brakes in the motors for axes 4, 5 and
6, by connecting the 24 VDC power supply.
Place the new motor unit in the gearbox.
Do not damage the pinion or the gear wheel!
Find the position of least play by turning the outgoing
shaft for axis 4 in intervals of 90°, one revolution in
all, to locate the area where the play for the axis 6
motor is the smallest.
Turn the motor for axis 5 one full revolution at a time,
five revolutions in all. Find the least play for axis 6
within this range.
Turn the motor for axis 6 one full revolutipon at a
time, three turns in all. Find the least play for axis 6
within this range.
Push the motor in a radial direction so that the play
is minimal within one motor revolution without the
gear "chewing".
Refit the motor with its attachment screws and
washers, motor.
Refill with oil, if drained.
Check the position of the three gaskets, located
between the motors and the connection box. Replace
them if damaged.
Refit the connection box.
Make sure the gaskets are seated properly!
Reconnect all the connectors.
© Copyright 2004-2018 ABB. All rights reserved.
4 Repair
4.7.8 Refitting of motor, axis 6
Continued
Information
Part no. is specified in Required
equipment on page 243.
Art. no. is specified in Required
equipment on page 243.
Connect to connector
R3.MP4/MP5/MP6
• +24V: pin 7
• 0V: pin 8.
Shown in the figure Location of
motor on page 243.
4 pcs, M6 x 25. Tightening
torque: 15 Nm.
Detailed in section
• Oil change, gearbox axis
5 and 6 (all robot ver-
sions) on page 121.
Part no. is specified in Required
equipment on page 243.
Shown in the figure Location of
motor on page 243.
Continues on next page
245