ABB IRB 4400/60 Product Manual page 205

13
Fitting of cylindrical roller bearing
The procedure below details how to fit the cylindrical roller bearings onto the
balancing device shaft and into the frame brackets.
1
2
3
4
5
Product manual - IRB 4400
3HAC022032-001 Revision: Q
Action
DANGER
Make sure all safety requirements are met
when performing the first test run. These are
further detailed in the section
may cause injury or damage on page
Action
Fit the inner ring of the bearing onto both end parts of
the balancing devices shaft.
Fit the outer ring of the bearing into both brackets with
a press toll, bearing.
Fit the sealing ring with dust lip with the same, but
turned, press tool, bearing.
Lubricate the bearing and the sealing with grease.
DANGER
Make sure all safety requirements are met when perform-
ing the first test run. These are further detailed in the
section First test run may cause injury or damage on
page 27.
© Copyright 2004-2018 ABB. All rights reserved.
4.6.1 Replacement of balancing device
Info/Illustration
First test run
27.
4 Repair
Continued
Info/Illustration
Shown in the figure Location
of balancing device on
page 198
Art. no. is specified in Re-
quired equipment on page 199
Part no. is specified in Re-
quired equipment on page 199
Art. no. and amount specified
in Required equipment on
page 199
205