Example Command Sequence - HP E1313A Manual

Example Command Sequence

92 Using the HP E1313/E1413
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This command sequence puts together all of the steps discussed so far in this
chapter.
*RST
Setting up Signal Conditioning (step 1 only for programmable SCPs).
INP:FILT:LPAS:FREQ 2,(@116:119)
INP:GAIN 64,(@116:119)
INP:GAIN 8,(@120:123)
Link channels to EU conversions (step 2).
SENS:FUNC:VOLT AUTO,(@100:107)
SENS:REF:TEMP THER,5000,AUTO,(@108)
SENS:FUNC:TEMP TC,T,AUTO,(@109:123)
Execute channel calibration (step 3).
*CAL?
Define and select scan list (step 4).
ROUT:SEQ:DEF LIST1,(@108:123,100:107)
ROUT:SCAN LIST1
Set sample timer (step 5).
SAMP:TIM LIST1,.00001
Configure the trigger system (step 6).
ARM:SOUR IMM
TRIG:COUN 10
TRIG:TIM .0007
TRIG:SOUR TIM
Specify data format (step 7).
FORM:DATA REAL,32
Select FIFO mode (step 8).
SENS:DATA:FIFO:MODE BLOCK
Initiate trigger system (step 9).
INIT:CONT OFF
INIT:IMM
Retrieve data (step 10).
SENS:DATA:FIFO:PART? <
Reset the module.
This is a *RST default.
This is a *RST default.
This is a *RST default.
read_data >
Chapter 3