Diagnostic:custom:linear; Diagnostic:custom:linear <Table_Range>,<Table_Block>,(@<Ch_List>) - HP E1313A Manual

DIAGnostic

DIAGnostic:CUSTom:LINear

Parameters
Comments
Usage
190 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DIAGnostic:CUSTom:LINear <
downloads a custom linear Engineering Unit Conversion table (in
the HP E1313/E1413. Contact your Hewlett-Packard System Engineer for more
information on Custom Engineering Unit Conversion for your application.
Parameter Parameter
Name Type
< table_range > numeric (float32)
< table_block > definite length block
data
< ch_list > channel list (string)
• <
table_block is a block of 8 bytes that define 4, 16-bit values. SCPI requires that
>
table_block include the definite length block data header. C-SCPI adds the
< >
header for you.
• <
table_range > specifies the range of voltage that the table covers
(from – < table_range >
be within 5% of one of the nominal values from the table above.
• <
ch_list > specifies which channels may use this custom EU table.
•
Related Commands: [SENSe:]FUNCtion:CUSTom
•
*RST Condition: All custom EU tables erased.
Program puts table constants into array table_block.
table_block
DIAG:CUST:LIN
SENS:FUNC:CUST:LIN 1,1,(@116:123)
INITiate then TRIGger module.
table_range table_block
>,<
Range of
.015625 | .03125 | .0625 | .125 | .25 | .5 |
1 | 2 | 4 | 8 | 16 | 32 | 64
See Comments below.
100 - 163
to + < table_range > ). The value you specify must
,(@116:123) Send table to HP E1413 for channels 16 - 23.
Link custom EU with channels 16 - 23.
ch_list
>,(@< >)
< table_block
Default
Values Units
volts
none
none
Chapter 5
> ) to