Trigger:timer[:Period]; Trigger:timer[:Period] <Trig_Interval - HP E1313A Manual

TRIGger:TIMer[:PERiod]

Parameters
Comments
Notes
Usage
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
TRIGger:TIMer[:PERiod] <
Used with the TRIGger:SOURce TIMer
Parameter Parameter
Name Type
< trig_interval > numeric (float32)
(string)
•
In order for the
TRIGger:TIMer
timer arming see the
ARM
•
The default interval is 1.0E-3 seconds.
milliseconds (ms), or microseconds (us). The resolution for
1. To change the TRIGger:TIMer:PERiod <
module, execute:
ARM:SOUR IMM
TRIGger:SOURce BUS
TRIG:TIM < new_interval
TRIG:SOUR TIM
2. To avoid a " Trigger Too Fast" error following
interval must be greater than:
TRIGger:TIMer
((number of channels in scan list +3)*
•
Related Commands: TRIGger:SOURce TIMer
ARM[:IMMediate] , INITiate:...
•
*RST Condition: TRIGger:TIMer:PERiod 1.0E-3
TRIG:TIM:PER 1.0E-2
TRIG:TIM:PER 1
trig_interval sets the interval between scan triggers.
>
trigger mode.
Range of
Values
1.0E-4 to 6.5536 | MIN | MAX
to start it must be Armed. For information on
subsystem in this command reference.
< trig_interval >
trig_interval
Must be IMM when SOUR not TIMer.
or HOLD To stop scanning.
> Change the timer interval.
Return to timed scans.
INITiate:IMMediate
SAMPle:TIMer
, ARM:SOURce
commands, TRIGger:SOURce?
Set the module to make a measurement scan
every 10 mS.
Set the module to make a measurement scan
once every second.
HP E1313/E1413 Command Reference
TRIGger
Default
Units
seconds
may be specified in
is 100 µs.
< trig_interval >
> without re- INIT ializing the
, the
) +30µs.
,
273