Output; Output:current:amplitude; Output:current:amplitude <Amplitude>,(@<Ch_List>) - HP E1313A Manual

Subsystem Syntax

OUTPut:CURRent:AMPLitude

Parameters
Comments
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The

OUTPut

subsystem is involved in programming source SCPs as well as
controlling the state of VXIbus TTLTRG lines 0 through 7.
OUTPut
:CURRent
:AMPLitude <
:AMPLitude? (@<
[:STATe] <
[:STATe]? (@<
:SHUNt < enable
:SHUNt? (@<
:TTLTrg
:SOURce <
:SOURce?
:TTLTrg< n >
[:STATe] <
[:STATe]?
:VOLTage
:AMPLitude <
:AMPLitude? (@<
OUTPut:CURRent:AMPLitude <
SCP channels specified by
typically used for four-wire resistance and resistance temperature measurements.
Parameter Parameter
Name Type
< amplitude > numeric (float32)
ch_list channel list (string)
< >
•
Select (or ) for measuring resistances of less than 8000 Ohms.
488E-6 MAX
Select (or ) for resistances of 8000 Ohms and above.
30E-6 MIN
may be specified in µA (ua).
amplitude
< >
amplitude ch_list
>,(@<
channel >)
enable >,(@< ch_list >)
channel >)
>,(@< ch_list >)
channel
>)
trig_source
>
ttltrg_cntrl >
amplitude ch_list
>,(@<
channel
>)
amplitude ch_list
>,(@<
to either 488 µA, or 30 µA. This current is
ch_list
< >
Range of
MIN | 30E-6 | MAX | 488E-6
100 - 163
HP E1313/E1413 Command Reference
OUTPut
OUTPut
>)
>)
sets the Current Source
>)
Default
Values Units
ADC
none
213