Arm:source - HP E1313A Manual

ARM
Usage

ARM:SOURce?

Usage
162 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
•
The Arm and Trigger Sources can be changed while the module is scanning (but
not in the continuous mode). This provides a way to stop triggering when you
want to change the
TRIGger:TIMer[:PERiod] <
ARM:SOURce IMMediate
TRIGger:SOURce BUS
or
TRIGger:SOURce HOLD
TRIGger:TIMer < new_interval
TRIGger:SOURce TIMer
•
When TRIGger:SOURce
INITiate:CONTinuous is
After that, the timer continues to run and the module goes to the wait-for-trigger state,
ready for the next timer trigger. An
the module to the trigger idle state after the current scan is completed. See
and
TRIGger:SOURce TRIGger:TIMer:MODE
•
While

ARM:SOURce

is
start a measurement scan.
•
Related Commands: ARM[:IMMediate]
INITiate:CONTinuous ON
•
*RST Condition: ARM:SOURce IMMediate
ARM:SOURce BUS
ARM:SOURce TTLTRG3
ARM:SOURce? returns the current arm source configuration. See the
ARM:SOURce command for more response data information.
•
Returned Value: Discrete, one of
TTLT7 . The C-SCPI type is string.
ARM:SOUR?
trig_interval
Must be IMMediate when SOURce not TIMer.
To stop scanning.
>
Change the timer interval.
Return to timed scans.
is TIMer , TRIGger:TIMer:MODE
ON , an ARM event is required only to trigger the first scan.
INITiate:CONTinuous OFF
for more details.
IMMediate , you need only
, ARM:SOURce?
, TRIGger:SOURce
Arm with ARM command.
Arm with VXIbus TTLTRG3 line.
BUS , HOLD , IMM
An enter statement return arm source
configuration.
. To do this, execute:
>
is set to SYNC , and
command will return
INITiate the trigger system to
, INITiate[:IMMediate]
, SCP , or TTLT0 through
Chapter 5
,