Input:filter[:Lpass]:Frequency; Input:filter[:Lpass]:Frequency? (@<Channel>) - HP E1313A Manual

Usage

INPut:FILTer[:LPASs]:FREQuency?

Parameters
Comments
Usage
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
INP:FILT:FREQ 100,(@100:119)
INP:FILT:FREQ 2,(@155)
INPut:FILTer[:LPASs]:FREQuency? (@<
currently set for channel. Non-programmable SCP channels may be queried to
determine their fixed cutoff frequency.
Parameter Parameter
Name Type
< channel > channel list (string)
•
<channel> must specify a single channel only.
•
This command is for programmable filter SCPs only.
•
Returned Value: Numeric value of Hz as set by the
INPut:FILTer:LPASs:FREQuency
•
Related Commands: INPut:FILTer[:LPASs]:FREQuency
INPut:FILTer[:LPASs][:STATe]
•
*RST Condition: MIN
INP:FILT:LPAS:FREQ? (@155)
INP:FILT:LPAS:FREQ? (@100)
Set cutoff frequency of 100 Hz for first 20
channels.
Set cutoff frequency of 2 Hz for channel 55.
channel returns the cutoff frequency
>)
Range of
Values
100 - 163
command. The C-SCPI type returned is float32.
Check cutoff frequency on channel 55.
Check cutoff frequency on channel 0.
HP E1313/E1413 Command Reference
INPut
Default
Units
none
,
205