Calculate:average[:State]; Calculate:average[:State] <Enable - HP E1313A Manual

CALCulate:AVERage[:STATe]

Notes
Parameters
Comments
Usage

CALCulate:AVERage[:STATe]?

Comments
Usage
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
CALCulate:AVERage[:STATe] <
averaging is enabled ( ON ) or disabled (
1. When CALCulate:AVERage[:STATe]
appear in a scan list only once, and use of
2. When
CALCulate:AVERage[:STATe]
Parameter Parameter
Name Type
< enable > discrete (string)
•
When averaging is on, each channel in the scan list(s) is measured a number of
times (as set by CALCulate:AVERage:COUNt
measurements becomes the reading stored for that channel.
•
Related Commands:
CALCulate:AVERage:COUNt
CALCulate:AVERage[:STATe]?
•
*RST Condition: CALCulate:AVERage:STATe OFF
CALC:AVER ON
CALCulate:AVERage[:STATe]?
is off.
•
Returned Value: Numeric value either
int16.
•
Related Commands: CALCulate:AVERage[:STATe]
CALCulate:AVERage:COUNt
CALC:AVER?
enable controls whether measurement
>
OFF ).
is ON , an individual channel number must
LISTL in not allowed.
is , channels must use manual ranging.
ON
Range of
Values
ON | OFF
). The average of those
,
Averaging for all scanned channels is ON.
returns a 1 if averaging is on, or a
1 or 0 . The C-SCPI type returned is
,
A subsequent enter statement will return 0
or 1.
HP E1313/E1413 Command Reference
CALCulate
Default
Units
none
0 if averaging
165