Input:filter[:Lpass][:State]; Input:filter[:Lpass][:State] <Enable>,(@<Ch_List>); Input:filter[:Lpass][:State]? (@<Channel>) - HP E1313A Manual

INPut

INPut:FILTer[:LPASs][:STATe]

Parameters
Comments
Usage
INPut:FILTer[:LPASs][:STATe]?
Parameters
Comments
Usage
206 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
INPut:FILTer[:LPASs][:STATe] <
programmable filter SCP channel. When disabled (
are in their "pass through" mode and provide no filtering. When re-enabled
( < enable > = ON ), the SCP channel reverts to its previously programmed setting.
Parameter Parameter
Name Type
< enable > discrete (string)
ch_list channel list (string)
< >
•
If the SCP has not yet been programmed,
frequency.
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
*RST Condition:
ON
INP:FILT:LPAS:STAT ON,(@115,117)
INP:FILT:LPAS:STAT OFF,(@100:115)
INPut:FILTer[LPASs][:STATe]? (@<
filtering for the specified channel.
Parameter Parameter
Name Type
< channel > channel list (string)
• <
channel > must specify a single channel only.
•
Returned Value: Numeric value either
The C-SCPI type returned is int16.
INP:FILT:LPAS:STAT? (@115)
INP:FILT? (@115)
enable ch_list enables or disables a
>,(@< >)
< enable > =
Range of
Values
ON | OFF
100 - 163
enables the SCP's default cutoff
ON
Channels 115 and 117 return to previously
set (or default) cutoff frequency.
Set channels 0 - 15 to "pass-through" state.
channel >) returns the currently set state of
Range of
Values
100 - 163
0 (off or " pass-through" ) or
Enter statement returns either 0 or 1.
Same as above.
OFF ), these channels
Default
Units
none
none
Default
Units
none
1 (on).
Chapter 5