Output:shunt[:State]; Output:shunt[:State] <Enable>,(@<Ch_List>); Output:shunt[:State]? (@<Channel>) - HP E1313A Manual

OUTPut

OUTPut:SHUNt[:STATe]

Parameters
Comments
Usage
OUTPut:SHUNt[:STATe]?
Parameters
Comments
Usage
216 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
OUTPut:SHUNt[:STATe] <
of bridge on Strain Bridge Completion SCPs. This can be used for diagnostic
purposes and characterization of bridge response.
Parameter Parameter
Name Type
< enable > boolean (uint16)
ch_list channel list (string)
< >
•
If ch_list specifies a non-strain SCP, Error +3007, " Invalid signal conditioning
< >
module" is generated.
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
Related Commands:
[SENSe:]FUNCtion:STRain:...
commands.
[SENSe:]STRain:...
•
*RST Condition:
OUTPut:SHUNt:STATe 0
OUTP:SHUN:STAT 1,(@116:119)
OUTPut:SHUNt[:STATe]? (@<
on the specified Strain SCP channel.
Parameter Parameter
Name Type
< channel > channel list (string)
• <
channel > must specify a single channel only.
•
If channel specifies a non-strain SCP, Error +3007, " Invalid signal
< >
conditioning module" is generated.
•
Returned Value: Returns
•
Related Commands: OUTPut:SHUNt[:STATe]
OUTP:SHUN:STAT? (@116)
enable ch_list adds shunt resistance to one leg
>,(@< >)
Range of
Values
1 | 0 | ON | OFF
100 - 163
on all Strain SCP channels.
Add shunt resistance at channels 16
through 19.
channel returns the status of the shunt resistance
>)
Range of
Values
100 - 163
1 or 0 . The CSCPI type returned is uint16.
Check status of shunt resistance on channel 16.
Default
Units
none
none
commands and
Default
Units
none
Chapter 5