Resetting the Module
Comments
376
Register-Based Programming
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Resetting the module places it in the Ready for Program State. The module
is reset according to Figure D-3.
Figure D-3. Resetting the HP E1313/E1413
•
The registers used are:
Control Register (base+04
–
Status Register (base+04
–
•
Writing a one (1) to bit 1 prevents the module from asserting the
SYSFAIL line when the module is reset.
See the Control Processor
State Diagram on page 381
)(write)
16
)(read)
16
Appendix D