Table of Contents
Advertisement
[SENSe:]
Usage
[SENSe:]FUNCtion:CUSTom:TCouple
Parameters
Comments
238
HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
INITiate:IMMediate
time if the filter is
range
may be specified in millivollts (mv).
<
>
•
If you are using amplifier SCPs, you should set them first and keep their settings
in mind when specifying a range setting. For instance, if your expected signal
voltage is to be approximately .1 VDC and the amplifier SCP for that channel has
a gain of 8, you must set
condition will exist.
•
The
command calibrates temperature channels based on Sense Amplifier
*CAL?
SCP setup at the time of execution. If SCP settings are changed, those channels
are no longer calibrated.
•
Related Commands:
DIAGnostic:CUSTom:PIECewise
[SENSe:]FUNCtion:TEMPerature
•
*RST Condition: All custom EU tables are erased.
Program must put table constants into array table_block.
DIAG:CUST:PIEC 1,table_block,(@108)
SENS:FUNC:CUST:REF .25,(@108)
Include this channel in a scan list with thermocouple channels (REF channel first).
INITiate then TRIGger module.
[SENSe:]FUNCtion:CUSTom:TCouple <
channels with the custom Engineering Unit Conversion table loaded with the
DIAGnostic:CUSTom:PIECewise
thermocouple and the
type
<
voltage table to be used for reference junction temperature compensation.
SENSe:FUNCtion:CUSTom:TCouple
matched to thermocouple wire you have characterized. Contact your
Hewlett-Packard System Engineer for more information on Custom Engineering
Unit Conversion for your application.
Parameter
Parameter
Name
Type
<
type
>
discrete (string)
range
numeric (float32)
<
>
<
ch_list
>
channel list (string)
•
See " Linking Channels to EU Conversion" in Chapter 3 for more information.
ON
and any channel specifies autorange.
<
range
>
no lower than 1 VDC or an input out-of-range
*CAL?
must be executed again.
,
[SENSe:]FUNCtion:CUSTom:TCouple
Send characterized reference transducer
table for use by channel 8.
Link custom reference temperature EU with
channel 8.
type
range
>,[<
command. The table is assumed to be for a
parameter will specify the built-in compensation
>
allows you to use an EU table that is custom
Range of
Values
E | J | K | N | R | S | T
.0625 | .25 | 1 | 4 | 16
(See Comments)
100 - 163
,
,
*CAL?
ch_list
links
>,](@<
>)
Default
Units
none
VDC
none
Chapter 5
Advertisement
Chapters
Table of Contents
