Calibration:setup - HP E1313A Manual

CALibration:SETup

Comments
Usage

CALibration:SETup?

Comments
Usage
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
causes the Channel Calibration function to be performed for

CALibration:SETup

every module channel. The Channel Calibration function calibrates the A/D Offset,
and the Gain/Offset for all 64 channels. This calibration is accomplished using
internal calibration references. For more information see
• CALibration:SETup
performs the same operation as the
since it is not a query command it does not tie-up the C-SCPI driver waiting for
response data from the instrument. If you have multiple HP E1313/E1413s in your
system you can start a CALibration:SETup
CALibration:SETup? command to complete the operation on each instrument.
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
Related Commands:
CALibration:SETup?
CAL:SET
:
CAL:SET
CAL:SET?
:
CAL:SET?
returns a value to indicate the success of the last
CALibration:SETup?
or operation.
*CAL? CALibration:SETup?
operation is complete.
CALibration:SETup
•
Returned Value:
Value
0
-1
-2
The C-SCPI type for this returned value is int16.
•
Related Commands:
CALibration:SETup
See CALibration:SETup
operation on each and then execute a
,
*CAL?
Start SCP Calibration on first HP E1413.
Start SCP Calibration on more HP E1413s.
Start SCP Calibration on last HP E1413.
Query for results from first HP E1413.
Query for results from more HP E1413s.
Query for results from last HP E1413.
returns the value only after the
Meaning
Cal OK
Cal Error
See Error Messages in Appendix B.
No results available No *CAL? or CALibration:SETup done.
,
*CAL?
HP E1313/E1413 Command Reference
CALibration
*CAL? on page 275.
command except that
*CAL?
CAL:SETup
Further Action
None
Query the Error Queue
(SYSTem:ERRor?)
Also run *TST?.
179