Terminal Module Options; Option A3E - HP E1313A Manual

Terminal Module Options

Option A3E

Note
56 Field Wiring
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Besides the standard terminal module with push-in connectors, the
HP E1313/E1413 can be ordered with the following two options. One
option (Option A3F) allows connection to an HP E1586 Rack Mount
Terminal Panel and the other option (A3E) allows direct connections to the
HP E1313/E1413 A/D Module's Faceplate using connectors.
HP E1313/E1413 Option A3E can be ordered if a crimp-and-insert terminal
module is desired. This allows you to crimp connectors onto wires which
are then inserted directly into the HP E1313/E1413 faceplate connector.
Refer to the pin-out diagram on pages 63 and 64 to make the connections.
The crimp-and-insert connector is shown in Figure 2-21.
The pin numbering on the crimp-and-insert connector may not agree with the
pin numbering on the HP E1413's faceplate connector. Use the pin
numbering on the faceplate connector to wire the crimp-and-insert connector.
Figure 2-21. Crimp-and-Insert Connector
Chapter 2