Ese <Mask; Ese; Esr; Gmc? <Name - HP E1313A Manual

*ESE <mask>
Bit # 7
Weighted Value 128
Event Power-on

*ESE?

*ESR?

*GMC? <name>

*IDN?

Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Standard Event Status Enable Register Command. Enables one or more events
in the Standard Event Status Register to be reported in bit 5 (the Standard Event
Status Summary bit) of the Status Byte Register. You enable an event by specifying
its decimal weight for < mask
sum of the decimal weights. The C-SCPI type for
6 5
64 32
User Command Execution
Request Error
Standard Event Status Enable Query. Returns the weighted sum of all enabled
(unmasked) bits in the Standard Event Status Register. The C-SCPI type for this
returned value is int16.
Standard Event Status Register Query. Returns the weighted sum of all set bits in
the Standard Event Status Register. After reading the register,
register. The events recorded in the Standard Event Status Register are independent of
whether or not those events are enabled with the *ESE command to set the Standard
Event Summary bit in the Status Byte Register. The Standard Event bits are described
in the command. The C-SCPI type for this returned value is int16.

*ESE

Get Macro Query. Returns arbitrary block response data which contains the
command or command sequence defined for
arbitrary block response data see page 156.
Identity Query. Returns the device identity. The response consists of the
following four fields (fields are separated by commas):
Manufacturer
–
Model Number
–
Serial Number (returns 0 if not available)
–
Driver Revision (returns 0 if not available)
–
Common Command Reference
> . To enable more than one event (bit), specify the
< mask
4 3
16 8
Device Dependent
Error Error
< name >
HP E1313/E1413 Command Reference
> is int16.
2 1 0
4 2 1
Query Request Operation
Error Control Complete

*ESR?

clears the
. For more information on
277