HP E1313A Manual page 120

Chapter 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Example Command Sequence
Card 1
n >,(@101,103,105,107) <n> can be 1 - 4.
ROUT:SEQ:DEF LIST<
ROUT:SCAN LIST< n >
SAMP:TIM LIST< n>,<t
>
c
TRIG:SOUR TIM
t
TRIG:TIM:PER < >
p
TRIG:TIM:MODE SYNC
TRIG:COUN 2
ARM:SOUR < source >
OUTP:TTLT< n >:SOUR FTR
OUTP:TTLT< n >:STAT ON
INIT:CONT ON
Card 2
n >,(@101,103,105,107) <n> can be 1 - 4.
ROUT:SEQ:DEF LIST<
n
ROUT:SCAN LIST< >
n t
SAMP:TIM LIST< >,< >
c
TRIG:SOUR TTLTrg< n >
TRIG:COUN < count >
INIT:IMM
Starting
ARM event, either hardware or software
Acquisition starts
Stopping Before Trigger Count is Reached
INIT:CONT OFF
TRIG:SOUR HOLD
TRIG:IMM
or
ABOR
Understanding the HP E1313/E1413
<t > can be 10µs to 32.768ms.
c
<t > can be .1ms - 6.5536 s.
p
Keep timer running during
INIT:CONT ON.
<source> can be BUS, EXT,
HOLD, IMM, or TTLTrg0 -
TTLTrg7.
1st trig will source TTLTrg.
Enable to drive selected TTLTrg
line. <n> can be 1 through 7.
<t > can be 10µs to 32.768ms.
c
Selects TTLTrg trigger source.
<count> can be 1 - 32768 or INF.
To master card.
Stops at end of scan list, still
initiated.
One more scan, now idle.
Stops immediately (must use
ABOR if TRIG:COUNt is INF).
119