HP E1313A Manual page 290

Category Command
Calibration *CAL?
Internal Operation *IDN?
*RST
*TST?
Status Reporting *CLS
*ESE <mask>
*ESE?
*ESR?
*SRE <mask>
*SRE?
*STB?
Macros *DMC <name>,<cmd_data>
*EMC 1 | 0
*EMC?
*GMC? <name>
*LMC?
*PMC
*RMC <name>
Synchronization *OPC
*OPC?
*TRG
*WAI
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
IEEE-488.2 Common Command Quick Reference
Title
Calibrate
Identification
Reset
Self Test
Clear Status
Event Status Enable
Event Status Enable query
Event Status Register query
Service Request Enable
Service Request Enable query
Read Status Byte query
Define Macro Command
Enable Macro Command
Enable Macros query
Get Macro query
Learn Macro query
Purge Macro Commands
Remove Individual Macro
Operation Complete
Operation Complete query
Trigger
Wait to Complete
HP E1313/E1413 Command Reference
Command Quick Reference
Description
Performs internal calibration on all 64 channels out to the
terminal module connector. Returns error codes or 0 for OK.
Returns the response:
HEWLETT-PACKARD,E1413C,<serial#>,<driver rev#>.
Resets all scan lists to zero length and stops scan triggering.
Status registers and output queue are unchanged.
Performs self test. Returns 0 to indicate test passed.
Clears all status event registers and so their status summary
bits (except the MAV bit).
Set Standard Event Status Enable register bits mask.
Return current setting of Standard Event Status Enable
Register.
Return Standard Event Status Register contents.
Set Service Request Enable register bit mask.
Return current setting of the Service Request Enable register.
Return current Status Byte value.
Assigns one, or a sequence of commands to a macro.
Enable/Disable defined macro commands.
Returns 1 for macros enabled, 0 for disabled.
Returns command sequence for named macro.
Returns comma-separated list of defined macro names.
Purges all macro commands
Removes named macro command.
Standard Event register's Operation Complete bit will be 1
when all pending device operations have been finished.
Places an ASCII 1 in the output queue when all pending
operations have finished.
Triggers module when TRIGger:SOURce is HOLD.
289