[Sense:]Data:cvtable:reset; [Sense:]Data:fifo[:All] - HP E1313A Manual

[SENSe:]

[SENSe:]DATA:CVTable:RESet

Comments
Usage

[SENSe:]DATA:FIFO[:ALL]?

Comments
Note
230 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

[SENSe:]DATA:CVTable:RESet

IEEE-754 " Not-a-number" .
•
The value of NaN is +9.910000E+037 (ASCII).
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
Related Commands:
[SENSe:]DATA:CVTable?
•
*RST Condition:
SENSe:DATA:CVTable:RESet
SENS:DATA:CVT:RES

[SENSe:]DATA:FIFO[:ALL]?

until all measurements are complete or until the number of readings returned
exceeds FIFO buffer size (65,024).
• SENSe:DATA:FIFO:ALL?
are being made) into a single large buffer, or can be used after one or more
SENSe:DATA:FIFO:HALF?
FIFO.
•
The format of readings returned is set using the
Returned Value: ASCII readings are returned in the form ±
•
For example 13.325 volts would be
followed by a comma (,). A line feed (LF) and End-Or-Identify (EOI) follow the
last reading. The C-SCPI data type returned is a string array.
REAL 32, REAL 64, and PACK 64, readings are returned in the
IEEE-488.2-1987 Indefinite Length Arbitrary Block Data format. This data
return format is explained in " Arbitrary Block Program and Response Data"
section on page 156 of this chapter. For REAL,32, each reading is 4 bytes in
length (the C-SCPI data type returned is a float32 array). For REAL,64 and
PACK,64, each reading is 8 bytes in length (the C-SCPI data type returned is a
float64 array).
Channel readings which are a positive overvoltage return
negative overvoltage return
values for each data format).
•
Related Commands: [SENSe:]DATA:FIFO:HALF?
sets all 64 Current Value Table entries to the
Clear the Current Value Table.
returns all readings remaining in the FIFO buffer
may be used to acquire all readings (even while they
commands to return the remaining readings from the
FORMat:DATA
+1.3325000E+001
IEEE -INF (see the table on page 200 for actual
command.
±
1.234567E 123 .
. Each reading is
IEEE +INF and a
Chapter 5