Route; Route:scan; Route:scan <Scan_List - HP E1313A Manual

ROUTe

Subsystem Syntax

ROUTe:SCAN

Parameters
Comments
LISTL Notes
Usage
220 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The ROUTe subsystem controls which of four Scan Lists will be executed at the
next trigger event, and defines the channel content of each Scan List.
ROUTe
scan_list
:SCAN <
:SEQuence:
:DEFine <
:DEFine? <
:POINts? <
ROUTe:SCAN < scan_list
for measurement scans.
Parameter Parameter
Name Type
< scan_list > discrete (string)
•
When is
ROUTe:SCAN
the scan lists specified by
1. When
ROUTe:SCAN
must contain at least 6 channels.
2. can only be selected while module is in Trigger Idle State (not
LISTL
3. When CALCulate:AVERage:STATe
•
Normally, the specified scan list number becomes effective when the Trigger
System moves from the Initiated State to the Wait-for-Trigger State. If
ROUTe:SCAN LIST1-LIST4
for the next scan. If INITiate:CONTinuous
IMMediate , ROUTe:SCAN
scanning event sequence.
•
Related Commands:
ABORt
•
*RST Condition: ROUTe:SCAN LIST1
ROUT:SCAN LIST3
>
scan_list >,(@< ch_list >)
scan_list >[,< mode >]
scan_list >
> establishes which of the four Scan Lists will be used
LIST1 | LIST2 | LIST3 | LIST4 | LISTL
, the module will automatically sequence through
LISTL
ROUTe:SEQuence:DEFine LISTL,(@<
selects (List-of-Lists), each scan list it specifies
LISTL
is ON , LISTL
is executed after this point, it will become effective
is ON and
will generate an error. Refer to Figure 5-3 for
, commands,
INITiate:...
The next scan list executed will be LIST3.
ROUTe
Range of Default
Values Units
ch_list .
>)
INITiated
is not allowed.
TRIGger:SOURce is
ROUTe:SEQuence:DEFine
Chapter 5
none
).