Status:operation:enable; Status:operation:enable <Enable_Mask - HP E1313A Manual

STATus:OPERation:ENABle

Parameters
Comments
Usage

STATus:OPERation:ENABle?

Comments
Usage
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
STATus:OPERation:ENABle <
will enable corresponding bits from the Event Register to set the Operation
Summary bit.
Parameter Parameter
Name Type
< enable_mask > numeric (uint16)
• <
enable_mask > may be sent as decimal, hex (#H), octal (#Q), or binary (#B).
•
VXI Interrupts: When Operation Status Group bits 4, 8, 9, 10, or 11 are enabled,
VXI card interrupts will occur as follows:
When the event corresponding to bit 4 occurs and then is cleared, the card will
generate a VXI interrupt. When the event corresponding to bit 8, 9, 10, or 11
occurs, the card will generate a VXI interrupt.
NOTE: In C-SCPI, the C-SCPI overlap mode must be on for VXIbus interrupts to
occur.
•
Related Commands:
*STB?
STATus:OPERation[:EVENt]?
•
Cleared By: STATus:PRESet
•
*RST Condition: No change.
STAT:OPER:ENABLE 1
STATus:OPERation:ENABle?
Register.
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type
returned is uint16.
•
Related Commands: *STB?
STATus:OPERation[:EVENt]?
•
*RST Condition: No change.
STAT:OPER:ENABLE?
enable_mask sets bits in the Enable Register that
>
Range of
Values
0 - 32767
, ,
SPOLL STATus:OPERation:CONDition?
,
STATus:OPERation:ENABle?
and power-on.
Set bit 0 in the Operation Enable Register.
returns the value of bits set in the Operation Enable
, SPOLL , STATus:OPERation:CONDition?
,
STATus:OPERation:ENABle
Enter statement returns current value of bits
set in the Operation Enable Register.
HP E1313/E1413 Command Reference
STATus
Default
Units
none
,
,
255