Output:current[:State]; Output:current[:State] <Enable>,(@<Ch_List>); Output:current[:State]? (@<Channel>) - HP E1313A Manual

OUTPut:CURRent[:STATe]

Parameters
Comments
Usage
OUTPut:CURRent[:STATe]?
Parameters
Comments
Usage
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
OUTPut:CURRent[:STATe] <
output on channels specified in
Parameter Parameter
Name Type
< enable > numeric (uint16)
ch_list channel list (string)
< >
• OUTPut:CURRent:STATe
channel that has been disabled, when re-enabled sources the same current set by
the previous
OUTPut:CURRent:AMPLitude
• OUTPut:CURRent:STATe
four-wire resistance (and resistance temperature device) circuits during execution
of for those channels.
CALibration:TARE
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
Related Commands:
OUTPut:CURRent:AMPLitude
•
*RST Condition: OUTPut:CURRent:STATe OFF
OUTP:CURR:STAT OFF,(@100,108)
OUTPut:CURRent[:STATe]? (@<
Source SCP channel specified by
Parameter Parameter
Name Type
channel
< > channel list (string)
• <
channel > must specify a single channel only.
•
Returned Value: Returns
returned is uint16.
•
Related Commands: OUTPut:CURRent[:STATe]
OUTP:CURR:STAT? (@108)
Execute enter statement here
enable ch_list enables or disables current
>,(@< >)
< ch_list > .
Range of
Values
1 | 0 | ON | OFF
100 - 163
does not affect a channel's amplitude setting. A
command.
is most commonly used to turn off excitation current to
(all channels)
Turn off current source channels 0 and 8.
channel >) returns the state of the Current
< channel > .
Range of
Values
100 - 163
1 for enabled, 0 for disabled. The C-SCPI type
, OUTPut:CURRent:AMPLitude
Query for state of Current SCP channel 8.
Enter query value, either 1 or 0.
HP E1313/E1413 Command Reference
OUTPut
Default
Units
none
none
,
CALibration:TARE
Default
Units
none
215