[Sense:]Strain:excitation; [Sense:]Strain:excitation <Excite_V>,(@<Ch_List>); [Sense:]Strain:excitation? (@<Channel>) - HP E1313A Manual

[SENSe:]
Usage

[SENSe:]STRain:EXCitation

Parameters
Comments
Usage
[SENSe:]STRain:EXCitation?
Parameters
Comments
248 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
•
Related Commands:
[SENSe:]FUNCtion:TEMPerature
*RST Condition: Reference temperature is 0 °C
•
SENS:REF:TEMP 40
[SENSe:]STRain:EXCitation <
voltage value to be used to convert strain bridge readings for the channels specified
by ch_list . This command does not control the output voltage of any source, but
< >
declares the excitation voltage applied by a voltage source outside the HP E1413.
Parameter Parameter
Name Type
excite_v numeric (float32)
< >
ch_list
< > channel list (string)
• <
ch_list > must specify the channel used to sense the bridge voltage, not the
channel position on a Bridge Completion SCP.
•
Related Commands:
[SENSe:]STRain:...
[SENSe:]FUNCtion:STRain:...
•
*RST Condition: 3.9 V
SENS:STRAIN:EXC 4,(@100:107)
[SENSe:]STRain:EXCitation? (@<
currently set for the sense channel specified by
Parameter Parameter
Name Type
channel
< > channel list (string)
•
Returned Value: Numeric value of excitation voltage. The C-SCPI type
returned is flt32.
• <
channel must specify a single channel only.
>
•
Related Commands: [SENSe:]STRain:EXCitation
Subsequent thermocouple conversion will
assume compensation junction at 40
degrees C.
excite_v ch_list specifies the excitation
>,(@< >)
Range of
Values
.01 - 99
100 - 163
commands,
commands
Set excitation voltage for channels 0
through 7 to +4 V.
channel >) returns the excitation voltage value
< channel > .
Range of
Values
100 - 163
Default
Units
volts
none
Default
Units
none
Chapter 5