Status:questionable:enable; Status:questionable:enable <Enable_Mask - HP E1313A Manual

STATus

STATus:QUEStionable:ENABle

Parameters
Comments
Usage

STATus:QUEStionable:ENABle?

Comments
Usage
260 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
STATus:QUEStionable:ENABle <
that will enable corresponding bits from the Event Register to set the Questionable
Summary bit.
Parameter Parameter
Name Type
< enable_mask > numeric (uint16)
• <
enable_mask > may be sent as decimal, hex (#H), octal (#Q), or binary (#B).
•
VXI Interrupts: When bits 9, 10, or 11 are enabled and C-SCPI overlap mode is
on (or if you are using non-compiled SCPI), VXI card interrupts will be enabled.
When the event corresponding to bit 9, 10, or 11 occurs, the card will generate a
VXI interrupt.
•
Related Commands: *STB?
STATus:QUEStionable:ENABle?
•
Cleared By:
STATus:PRESet
•
*RST Condition: No change.
STAT:QUES:ENABLE 128
STATus:QUEStionable:ENABle?
Enable Register.
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type
returned is uint16.
•
Related Commands: *STB?
STATus:QUEStionable:ENABle
•
*RST Condition: No change.
STAT:QUES:ENABLE?
enable_mask sets bits in the Enable Register
>
Range of
Values
0 - 32767
, SPOLL , STATus:QUEStionable:CONDition?
, STATus:QUEStionable[:EVENt]?
and power-on.
Set bit 7 in the Questionable Enable
Register.
returns the value of bits set in the Questionable
, SPOLL , STATus:QUEStionable:CONDition?
, STATus:QUEStionable[:EVENt]?
Enter statement returns current value of bits
set in the Questionable Enable register
Default
Units
none
,
,
Chapter 5