Calculate:limit:lower:data; Calculate:limit:lower[:State]; Calculate:limit:lower:data? (@<Channel>); Calculate:limit:lower[:State] <Enable>,(@<Ch_List>) - HP E1313A Manual

CALCulate

CALCulate:LIMit:LOWer:DATA?

Parameters
Comments
Usage

CALCulate:LIMit:LOWer[:STATe]

Parameters
Comments
Usage
170 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
CALCulate:LIMit:LOWer:DATA? (@<
currently set for the channel specified by
Parameter Parameter
Name Type
< channel > channel list (string)
• <
channel > must specify a single channel.
•
Returned Value: Numeric. The C-SCPI type returned is float32.
•
Related Commands:
CALCulate:LIMit:LOWer:DATA
CALC:LIM:LOW:DATA? (@106)
CALCulate:LIMit:LOWer[:STATe] <
testing of lower limits for channels specified in
Parameter Parameter
Name Type
< enable > discrete (string)
ch_list
< > channel list (string)
•
If
CALCulate:LIMit:LOWer[:STATe]
exceeded status. If
CALCulate:LIMit:LOWer[:STATe]
a limit exceeded status regardless of the setting of
•
Related Commands: CALCulate:LIMit[:STATe]
•
*RST Condition: CALCulate:LIMit:LOWer:STATe OFF
CALC:LIM:LOW:STAT ON,(@100:107)
channel returns the lower limit value
>)
< channel > .
Range of
Values
100 - 163
Return the lower limit set for channel 6.
enable ch_list enables or disables
>,(@< >)
ch_list .
< >
Range of
Values
ON | OFF
100 - 163
is , an overrange will not cause a limit
OFF
is , an overrange will cause
ON
CALCulate:LIMit:LOWer:DATA
, CALCulate:LIMit:UPPer[:STATe]
Enable lower limit testing for channels 0
through 7.
Default
Units
none
Default
Units
none
none
.
Chapter 5