Calibration:store; Calibration:store <Type - HP E1313A Manual

CALibration

CALibration:STORe

Note
Parameters
Comments
Usage
Command
Sequence
180 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
type
CALibration:STORe <
constants into Flash Memory (Electrically Erasable Programmable Read Only
Memory). When < type > =
calibration using the most recently measured
resistance, and stores these to Flash Memory. When
the most recently measured
The HP E1313/E1413's Flash Memory has a finite lifetime of approximately ten
thousand write cycles (unlimited read cycles). While executing
once every day would not exceed the lifetime of the Flash Memory for approximately
27 years, an application that stored constants many times each day would unnecessarily
shorten the Flash Memory's lifetime.
Parameter Parameter
Name Type
< type > discrete (string)
•
The Flash Memory Protect jumper (JM2201) must be set to the " PROG" position
before executing this command (see Chapter 1).
•
Channel offsets are compensated by the
not stored in the Flash Memory. There is no need to use the
TARE command for channels which are recalibrated frequently.
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
Related Commands:
CALibration:VALue:RESistance
•
*RST Condition: Stored calibration constants are unchanged.
CAL:STOR ADC
CAL:STOR TARE
Storing A/D Cal Constants
Perform complete A/D calibration, then...
CAL:STOR ADC
Storing Channel Tare (offset) Values
CAL:TARE < ch_list >
stores the most recently measured calibration
>
ADC , the module sets its Analog-to-Digital Converter
CALibration:VALue
<
CALibration:TARE channel offsets into Flash Memory.
Range of
ADC | TARE
CALibration:TARE
Store cal constants in non-volatile memory
after A/D calibration.
Store channel offsets in non-volatile
memory after channel tare.
To correct channel offsets.
for voltage and
type > = TARE , the module stores
CALibration:STORe
Default
Values Units
none
command even when
CALibration:STORe
,
CALibration:VALue:VOLTage
Chapter 5