Status:operation:condition - HP E1313A Manual

STATus
The Operation
Status Group
Bit # Dec Value Hex Value
0 1
1-3
4 16
5-7
8 256
9 512
10 1024
11 2048
12-15

STATus:OPERation:CONDition?

Comments
Usage
254 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The Operation Status Group indicates the current operating state of the HP E1413.
See Table 5-3 for the bit assignments.
Bit Name
0001 Calibrating
16
0010 Measuring
16
0100 Scan Complete
16
0200 SCP Trigger
16
0400 FIFO Half Full
16
0800 Limit Test Exceeded
16

STATus:OPERation:CONDition?

set in the Condition Register.
•
The Condition Register reflects the real-time state of the status signals. The
signals are not latched, and therefore, past events are not retained in this register
(see STATus:OPERation[:EVENt]?
•
Returned Value: Decimal weighted sum of all set bits. The C-SCPI type
returned is uint16.
•
Related Commands: *CAL?
STATus:OPERation[:EVENt]?
STATus:OPERation:ENABle?
•
*RST Condition: No Change.
STATUS:OPERATION:CONDITION?
Table 5-3. Operation Status Group
Description
Set by CALibration:TARE, and CALibration:SETup.
Cleared by CALibration:TARE?, and
CALibration:SETup?. Set while *CAL? executes and
reset when *CAL? completes.
Set by CALibration:CONFigure:VOLTage or
CALibration:CONFigure:RESistance.
Cleared by CALibration:VALue:VOLTage or
CALibration:VALue:RESistance.
Not Used
Set when instrument INITiated. Cleared when
instrument returns to Trigger Idle State.
Not Used
Set when each pass through a Scan List completed (may
not indicate all measurements have been taken when
INITiate:CONTinuous is ON or TRIGger:COUNt >1).
An SCP has sourced a trigger event (future
HP 1413 SCPs).
The FIFO contains at least 32,768 readings.
One or more limit tests was exceeded.
Not Used
returns the decimal weighted value of the bits
).
, CALibration:ZERO , INITiate[:IMMediate]
, STATus:OPERation:ENABle
Enter statement will return value from the
Condition Register.
,
,
Chapter 5