Diagnostic:calibration:tare[:Otdetect][:Mode]; Diagnostic:calibration:tare[:Otdetect][:Mode] <Mode - HP E1313A Manual

DIAGnostic

DIAGnostic:CALibration:TARE[:OTDetect][:MODE]

Parameters
Comments
Usage

DIAGnostic:CALibration:TARE[:OTDetect][:MODE]?

Comments
188 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
DIAGnostic:CALibration:TARE[:OTDetect][:MODE] <
Transducer Detect current will be turned off (the default mode) or left on during the
CALibration:TARE operation.
Parameter Parameter
Name Type
< mode > boolean (uint 16)
•
When < mode > is set to
their OTD current off. When
on (
DIAGnostic:OTDetect ON,(@<
current left on.
•
By default ( ) the
*RST CALibration:TARE?
with the OTD circuitry disabled. This is done for two reasons.
1. Most users do not leave OTD enabled while taking readings.
2. The CALibration:TARE
However, for users who intend to make readings with OTD enabled, setting
DIAGnostic:CALibration:TARE:OTDetect:MODE 1
command to perform the calibration with OTD enabled
CALibration:TARE
(on channels specified by the user with
•
Related Commands:
CALibration:TARE
DIAGnostic:CALibration:TARE[:OTDetect][:MODE]?
•
*RST Condition: DIAGnostic:CALibration:TARE:OTDetect:MODE 0
Configure OTD on during CAL:TARE.
DIAG:CAL:TARE:MODE 1
CAL:TARE?
DIAGnostic:CALibration:TARE[:OTDetect][:MODE]?
mode for controlling Open Transducer Detect current while performing
CALibration:TARE operation.
•
Returns a 0 when OTD current will be turned off during
1
Returns when OTD current will be left on during
The C-SCPI type returned is int16.
•
Related Commands: DIAGnostic:CALibration:TARE[:OTDetect][:MODE]
DIAGnostic:OTDetect[:STATe]
•
*RST Condition:
DIAGnostic:CALibration:TARE:OTDetect:MODE 0
Range of
0 (the *RST Default), channels are tare calibrated with
< mode > is 1 , channels that have their OTD current
ch_list )) are tare calibrated with their OTD
>
command will calibrate all channels
operation takes much longer with OTD enabled.
DIAGnostic:OTDetect:STATe
,
CALibration:TARE?
Set mode for OTD to stay on.
Start channel tare cal.
,
CALibration:TARE?
mode sets whether Open
>
Default
Values Units
0 | 1 volts
will force the
).
,
, DIAGnostic:OTDetect[:STATe]
returns the currently set
.
CALibration:TARE
CALibration:TARE operation.
,
Chapter 5