Input:gain; Input:gain <Chan_Gain>,(@<Ch_List>); Input:gain? (@<Channel>) - HP E1313A Manual

INPut:GAIN

Parameters
Comments
Usage
INPut:GAIN?
Parameters
Comments
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
chan_gain
INPut:GAIN <
amplifier Signal Conditioning Plug-ons.
Parameter Parameter
Name Type
< chan_gain > numeric (float32)
discrete (string)
< ch_list > channel list (string)
•
A programmable amplifier SCP has a choice of several discrete gain settings. The
gain set will be the one closest to the value specified by
SCP manual for specific information on the SCP you are programming. Sending
will program the highest gain available with the SCP installed. Sending
MAX
will program the lowest gain.
•
Sending a value for < gain
setting allowable for the SCP will generate Error -222, " Data out of range" .
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
Related Commands:
INPut:GAIN?
•
*RST Condition: Gain set to
INP:GAIN 8,(@100:119)
INP:GAIN 64,(@155)
channel
INPut:GAIN? (@<
Parameter Parameter
Name Type
< channel > channel list (string)
• <
channel > must specify a single channel only.
•
If the channel specified does not have a programmable amplifier,
will return the nominal as-designed gain for that channel.
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
Returned Value: Numeric value as set by the
The C-SCPI type returned is float32.
ch_list sets the channel gain on programmable
>,(@< >)
See Comments below |
MIN | MAX
> that is greater than the highest or less than the lowest
.
MIN
Set gain of 8 for first 20 channels.
Set gain of 64 for channel 55.
returns the gain currently set for channel.
>)
INPut:GAIN
HP E1313/E1413 Command Reference
INPut
Range of Default
Values Units
100 - 163 none
< gain > . Refer to your
Range of Default
Values Units
100 - 163
INPut:GAIN?
command.
none
MIN
none
207