Input; Input:filter[:Lpass]:Frequency; Input:filter[:Lpass]:Frequency <Cutoff_Freq>,(@<Ch_List>) - HP E1313A Manual

INPut

Subsystem Syntax

INPut:FILTer[:LPASs]:FREQuency

Parameters
Comments
204 HP E1313/E1413 Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The INPut subsystem controls configuration of programmable input Signal
Conditioning Plug-Ons (SCPs).
INPut
:FILTer
[:LPASs]
:FREQuency <
:FREQuency? (@<
[:STATe] <
[:STATe]? (@<
:GAIN < chan_gain
:GAIN? (@<
wvolt_type
:LOW <
:LOW? (@<
INPut:FILTer[:LPASs]:FREQuency <
frequency of the filter on the specified channels.
Parameter Parameter
Name Type
cutoff_freq
< > numeric (float32)
(string)
ch_list
< > channel list (string)
• <
cutoff_freq > may be specified in kiloHertz (khz). A programmable Filter SCP
has a choice of several discrete cutoff frequencies. The cutoff frequency set will
be the one closest to the value specified by cutoff_freq. Refer to Chapter 6 for
specific information on the SCP you are programming.
•
Sending MAX for the cutoff_freq selects the SCP's highest cutoff frequency.
Sending for the cutoff_freq selects the SCP's lowest cutoff frequency.
MIN
To disable filtering (the " pass through" mode), execute the
INPut:FILTer:LPASs:STATe OFF
•
Sending a value greater than the SCP's highest cutoff frequency or less than the
SCP's lowest cutoff frequency generates Error -222, " Data out of range" error.
•
This command will cause Error +3000, "illegal while initiated" if trigger is initiated.
•
Related Commands: INPut:FILTer[:LPASs]:FREQuency?
INPut:FILTer[:LPASs][:STATe]
•
*RST Condition: Set to
cutoff_freq
>,(@<
channel >)
enable ,(@< channel
channel >)
>,(@< ch_list >)
channel
>)
ch_list
>,(@< >)
channel >)
cutoff_freq
>,(@<
Range of
Values
See Comments below.
MIN | MAX
100 - 163
command.
MIN .
INPut
ch_list
>)
>)
ch_list sets the cutoff
>)
Default
Units
Hz
none
,
Chapter 5