The Difference Between The Image Positions Of The Scaler; Audio Interface; Transmitter Mode - F100/R100 Models; Receiver Mode - F100/R100 Models - Lightware UBEX-PRO20-HDMI-F100 User Manual

Hide thumbs Also See for UBEX-PRO20-HDMI-F100:
Table of Contents

Advertisement

 
 
5. UBEX Concept
5. UBEX Concept
5.1.9. The Difference between the Image Positions of the Scaler
The following section helps to understand how the image position settings of the scaler works. Three
different image positions are available: stretch, fit and center.
ATTENTION!

The scaler settings are available on the HDMI in 1 port of the transmitter and the HDMI out 1
port of the receiver/transceiver operation modes only.
The aspect ratio of the original stream and the sink device are different in the following examples.
Stretch
The aspect ratio of the stream is distorted because it is adjusted to the aspect ratio of the sink.
Fit
The picture is adjusted to the resolution of the sink and the aspect ratio of the stream is kept, thus, the whole
picture will be displayed without cropping. The scaler fills the extra image part with black pixels.
Center
The scaler crops the center part of the stream with the resolution of the sink.
series – Extender Application Mode – User's Manual
series – Extender Application Mode – User's Manual
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
5.2. Audio Interface
5.2.1. Transmitter Mode - F100/R100 Models
Port Diagram
The port diagram is valid for the
following UBEX endpoint model:
UBEX-PRO20-HDMI-F100
UBEX-PRO20-HDMI-R100
series
Description
The transmitter receives HDMI audio
signals via the two HDMI input ports.
The audio streams are transmitted
toward the remote endpoint device
over the SFP+ links.
Audio port diagram of the F100/R100 transmitter in connection with
The two source streams can be
selected to any output port on the remote endpoint side. The crosspoint setting is available in the transmitter as well.
The HDMI output ports of the transmitter are HDMI loop-back ports and can be used as local HDMI outputs.
5.2.2. Receiver Mode - F100/R100 Models
Port Diagram
The port diagram is valid for the following UBEX endpoint model:
UBEX-PRO20-HDMI-F100
UBEX-PRO20-HDMI-R100 series
Audio port diagram of the F100/R100 receiver in connection with an F110 endpoint
59
59
an F110 endpoint

Advertisement

Table of Contents
loading

Table of Contents