Electrical Connections; Locking 12V Dc Connection; Dc Connection; Vga Connector - Lightware UMX-TPS-TX120 User Manual


  
3. Installation
3.4. Electrical Connections
3.4.1. Locking 12V DC Connection
UMX-TPS-TX100 series transmitters are built with locking 12V DC connector. Do not forget to turn the plug
clockwise direction before disconnecting the power adaptor.
WARNING!
Always use the supplied 12V power adaptor. Warranty void if damage occurs due to use of a
different power source.
3.4.2. 48V DC Connection
FP/WP-UMX-TPS-TX100 series transmitters are built with 2-pole Phoenix connector for 48V DC
1A power connection.
2-pole Phoenix connector and plug pin assignments
3.4.3. VGA Connector
The transmitter provides a standard 15-pole D-SUB female connector for connecting
VGA devices. Always use high-quality VGA cable for connecting sources and
displays; using a VGA cable where all the pins are wired (including the DDC channel's
wires) is highly recommended.
3.4.4. HDMI Connector
The extender provides standard 19-pole HDMI connector for input. Always use high quality
HDMI cable for connecting sources and displays.
Locking DC connector
#power
Pin nr. Signal
1 +
2 -
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
3.4.5. DisplayPort Connector
UMX-TPS-TX140, UMX-TPS-TX140-Plus, UMX-TPS-TX140K, WP-UMX-TPS-TX130-US, and
WP-UMX-TPS-TX130-Plus-US models provide standard 20-pole DisplayPort connector for
input. Always use high quality DP cable for connecting DisplayPort devices.
3.4.6. DVI-I Connector
UMX-TPS-TX130, UMX-TPS-TX140, UMX-TPS-TX140K and UMX-TPS-TX140-Plus transmitters provide a
standard 29-pole DVI-I connector for input where digital and analog pins are connected internally. Hence
users can use the connector receiving DVI-A (analog video) and DVI-D signals (digital video and digital
audio) as well.

ATTENTION! Only one (DVI-A or DVI-D) mode is available at a time. You can use the Video Select button
to choose the input source.
Always use high quality DVI cable for connecting DVI devices.
The following drawing and table show the pinout of DVI-I connector and the position of analog and digital
signal pins.
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Signal Pin Signal
TMDS Data2- 16 Hot Plug Detect
TMDS Data2+ 17 TMDS Data0-
TMDS Data2 Shield 18 TMDS Data0+
not connected 19 TMDS Data0 Shield
not connected 20 not connected
DDC Clock 21 not connected
DDC Data 22 TMDS Clock Shield
Analog Vertical Sync 23 TMDS Clock+
TMDS Data1- 24 TMDS Clock-
TMDS Data1+ C1 Analog Red
TMDS Data1 Shield C2 Analog Green
not connected C3 Analog Blue
not connected C4 Analog Horizontal Sync
+5V Power C5 GND
GND (for +5V)
33