Keeping The Configuration Settings - Lightware HDMI-3D-OPT-TX210A User Manual


  
8. Firmware Upgrade
8.5. Keeping the Configuration Settings
User can keep all configuration settings and restore to the device after firmware upgrading or can choose to
perform a factory reset – it means all settings will be erased in the device. For the detailed information about
saved data refer to Content of Backup File
The following flow chart demonstrates how this function works in the background.
Start Backup
The flow chart of the firmware upgrade procedure
The details about the procedure:
when firmware upgrade starts, the
first step is making a backup of the
settings of the device. The firmware
package checks the backup data and
if it is needed, a conversion is applied
to avoid incompatibility problems
between the firmware versions. If you
do not want to keep configuration
settings, you can set the Factory reset
option enabled.
The instruction in the firmware
package of the device will inform
you about this function availability,
reading it is highly recommended in
every case.
ATTENTION! In specific cases restoring cannot be applied fully and certain settings are not copied back
to the device. If a warning message appears, user can get back the original data from the backup. Logs of
the upgrade procedure contain all backup data, it can be exported at the end of the upgrade procedure. In
case of any question, please contact support@lightware.com.
ATTENTION! In certain cases, the new firmware version requires setting all parameters to set factory
defaults. In this case, the "Factory reset" option is enabled by default and not changeable by the user, see
details in the Firmware Components
ATTENTION! The feature is only supported by LDU version 1.3.0 and above.
section.
Upgrading Factory reset Conversion/Restore
Instructions page in the optical extender firmware package
section.
HDMI-3D-OPT series – User's Manual
End
82